Arc Welding Service

Gas Cutting

HUAWEI HK-72T HK-72T

HK-72T

The main body is made of high strength aluminum alloy, produced precisely by die-casting, light and compact.
The weight is 5.6kgs, easy for operating.
Attached with angle gauge which can make torch turn precisely to bevel.
Attached with clutch unit, loosing the handle of clutch, the machine can move along the rail steadily.
The rail is made of hard rubber which can be used for three dimension and two-dimension curve cutting. Inside of rubber rail there is the flexible core material which can avoid uneven cutting occurred by some general rubber rail.
Mainly used in different shapes of steel cutting such as profiled bar, boiler. Shipbuilding, and curve plate,etc.

Specification

1. Weight:	：11kgs (including rails)
Main body:	：4.5kg
Rail:	：6.5 kg
2.Overall size of main body:	：1905mm×195 mm×140 mm
3.Rail size: （length × width × height）	：1000 mm×42 mm×30 mm，Lengthen type
	1D (Straight AL rail with 4pc magnet)
	2D (Two dimension rubber rail with 5pc magnet)
	3D (There dimension rubber rail with 5pc magnet)
4. Power	：ＡＣ220V±10％
5. Speed control	：knob switch
6. Cutting speed	：150～700mm/min
7. Cutting angle	：0-45 degree
8. drive	：gear-rack driving mode
9. Cutting thickness:	：5～30mm（standard accessory）
10.Tip	：G02（suitable for acetylene）or G03（suitable for propane）
12. gas	：oxygen, acetylene or liquefied petroleum gas
13. smallest radius of curve	：2,000mm ( three-dimensional cutting track)
13. smallest radius of curve	：2,500mm ( two-dimensional cutting track)

Description: https://www.huawei-cutting.com/upfile/2016/03/04/20160304144125_493.png

1. Handle: Catch the handle when you carry machine.	10. Thermal baffle: To prevent the heat diffusing into the inner of machine.
2. Switch: When it is set on arrow direction, the machine starts to walk towards to this direction.	11. torch
	12. groove cutting screw
3. Speed controller: Increase the speed if it is rotated clockwise.	13. Torch lifting knob: It is used to adjust the vertical position of torch.
4. Control panel: Switch and speed controller is used to control machine.	14. Rubber track: There are three types: 1D――straight AL track; 2D――two-dimensional cutting track; 3D-- three-dimensional cutting track. Choose suitable track according to the sharp of work.
5. Host machine
6. Clutch rod: When it is on right, the clutch is OFF. When it is on left, the clutch is ON.	15. Torch sliding knob: To adjust the horizontal position.
	16. Hose: Connect them between distributor and torch. The three hoses are used individually for fuel gas （red）, preheating oxygen (blue) and cutting oxygen (blue).
7. Control rod: Use it to assemble or demount track.
8. Magnet: It fixes the track to steel plate. Use control rod to make magnet be on or off.	17. valve
	18. Gas distributor: It is used to control the flow of preheating oxygen, fuel gas and cutting oxygen to reach best flame.
9. Sliding roller wheel: The wheel and track are used to keep machine stable.